Woodway Engineering Ltd
Lower Road, Barnacle
Coventry, CV7 9LD
United Kingdom
Tel: +44 (0) 24 76 841750
Fax: +44 (0) 24 76 621796
www.woodwayengineering.com
I N S T A L L A T I O N G U I D E
3
Installing your Multi-Link
Programming your Multi-Link
Using your Multi-Link
Dimensions
When mounting the Multi-Link, it is important to consider the position of the switch panel for safety and
accessibility. This should not interfere with the driver or the vehicle controls. The switch panel orientation can
be vertical or horizontal.
Please refer to the Whelen Installation and
Programming Guide for full details on programming
your Multi-Link. Settings will be configured using
Whelen’s Command software, which is free to
download from whelen.com.
Some options you can select when programming
your Multi-Link:
• All 15 buttons have active warning lights
• Any button can be set to momentary,
latching or cyclic
• You can program button/s to activate a number of
other buttons
• You can use buttons as a warning light activated via
an external source
• You can illuminate your buttons for night time use,
with variable intensity set in the program
• The Core can program any button to operate the
built in microphone for the PA system.
Where the mounting bracket is used, screw in the
hardware as shown on the right. The handset will
then slide onto the bracket and clip in place.
If you are hard mounting to an existing bracket, the
screws used should not protrude more than 10mm
into the switch panel, or damage could occur.
The Multi-Link switch panel should be connected
directly to the Whelen Core module, or via the CAT5
extension cable supplied with the Core, using the
RJ45 to RJ45 inline connector.
166mm
51mm
24mm
