Woodward easYlite-200, Manual, Page: 17 / 34

Fig. 3: Dimensions easYlite-200 housing
Proceed as follows to install the unit:
1.
Panel cutout
Cut out the panel according to the dimensions in Fig. 3
2. Remove terminals
Loosen the wire connection terminal screws on the back of
the unit and remove the wire connection terminal strip if
required.
3. Loosen clamping screws
Loosen the four clamping screws until they are almost flush
with the clamp inserts and tilt the clamp inserts down by 45°
to remove them from the housing. Do not completely remove
the screws from the clamp inserts.
4. Insert unit into the cutout
Insert the unit into the panel cutout. Verify that the unit fits
correctly in the cutout. If the panel cutout is not big enough,
enlarge it accordingly. Ensure that the gasket is placed prop‐
erly if used. Ensure that the paper strip is not pinched
between gasket and panel to maintain isolation.
5. Attach clamp inserts
Re-install the clamp inserts by tilting the insert to the angle of
45°. Insert the nose of the insert into the slot on the side of
the housing. Raise the clamp insert so that it is parallel to the
control panel.
6. Tighten clamping screws
Tighten the clamping screws until the control unit is secured
to the control panel. Over tightening of these screws may
result in the clamp inserts or the housing breaking.
7. Reattach terminals
Reattach the wire connection terminal strip and secure with
the side screws.
Tighten the clips so that they are tight - but not too
tight - in order to achieve the best IP protection
result!
Installation
Installation
37903A easYgen Expansion Module | LED Lamp Expansion Module 17