-36-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
J<I
M
@:<
The feed rollers must be aligned correctly with the table
to maintain a smooth and straight feed.
KfZ_\Zbk_\]\\[ifcc\i$kf$kXYc\Xc`^ed\ek#[fk_\j\
jk\gj1
(
.
DISCONNECT THE PLANER/MOULDER FROM POWER!
)
. Remove the chip deflector lock pin, and set the chip
deflector aside.
*
. Refer
to
=`^li\
54
, and make a wooden gauge block
as outlined.
+
. Place the finished block on the table, directly under
one end of the infeed roller (
=`^li\
55
).
,
. Lower the cutterhead housing so the infeed roller
barely touches the gauge block on the lowest end of
the roller (
=`^li\
55
).
-
. Slide the block over to the other end of the roller.
.
. Using a set of feeler gauges, measure the gap
between the roller and the block.
—If the gap is more than 0.005", then proceed to
Step
8
and adjust the swing arm lower so the gap is less
than 0.005".
/
. Loosen the cap screw shown in
=`^li\
56
, then
rotate the cam nut until the swing arm lowers and
the roller just touches the block.
0
. Remove the gauge block and retighten the cap screw.
('
. Check and adjust the outfeed roller next.
((
. When both rollers are adjusted, check and adjust the
feed roller height and spring tension as outlined in
the
Feed Roller Height and Spring Tension
section
on
Page 21
.
()
. When finished, reinstall the chip deflector.
=\\[Ifcc\i$kf$KXYc\
8c`^ed\ek
=`^li\
55
.
Gauge block.
=`^li\
56
.
Feed roller adjustment.
Cam
Nut
Cap
Screw
Gauge
Block
Feed
Roller
=`^li\
54
.
Gauge block plans.
45°
2
4
4
1
1 2
1 2
Grain Dir
ec
tion
Side View
Front View
Swing
Arm
