-23-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
FG
<
I
8
K@FEJ
Before using this planer/moulder, inspect each and every
workpiece for the following problems, and be familiar
with the hardness of the wood workpiece.
Each workpiece must have at least one flat surface to
slide along the planer/moulder table. To create a flat
surface, pass the workpiece over a jointer (
=`^li\
31
). Defects such as twisting, loose knots or severe
cracks may make the stock unusable.
When possible, square up stock before moulding.
Plane equal amounts on each side of the board to
reduce the chance of twisting or cupping.
Recognize the workpiece density. Planing is more
difficult in hard species of wood and may require
several shallow cuts to reach the desired thickness.
=`^li\
32
lists the hardness of many common woods
based on shear strength.
Only use clean lumber. Scrape off all glue from joined
boards before processing. Remove all dirt, nails,
staples, imbedded gravel, etc. from any workpiece
you plan on using. Metal or gravel in a workpiece will
instantly damage the knives.
•
Avoid processing a workpiece with a high moisture
content. Wood with more than 20% moisture, or wood
that has been exposed to rain or snow, will cut poorly
and cause unnecessary wear on the knives and motor.
•
Process ONLY wooden workpieces. Never process
particle board, plywood, MDF, laminates, or other
synthetic materials.
Feed wood in the same direction as the grain. Never
feed end-cut or end-grained lumber into the planer/
moulder.
Nfibg`\Z\@ejg\Zk`fe
=`^li\
31
.
Face joint the concave side of
cupped workpiece before milling.
TYPE ............. SHEAR (PSI
)
Black Locust ............. 2,480
Sugar Maple ............. 2,330
Pecan Hickory ........... 2,080
White Oak ............... 2,000
White Ash ................ 1,950
Black Cherry ............ 1,700
American Elm ........... 1,510
Black Walnut ............ 1,410
Red Alder ................ 1,370
Basswood ................ 1,280
Cottonwood ............. 1,160
Western Larch ...........1,150
Tamarack .................1,130
Douglas Fir .............. 1,080
Alaska Cedar ............ 1,050
Sitka Spruce ............. 1,000
Sugar Pine ................. 980
Cypress ..................... 940
Redwood (OG) ............ 930
Red Cedar ................. 860
White Pine ................. 850
Balsam Fir ................. 710
=`^li\
32
.
Wood density table.
?8I;
JF=K
Portion
Removed With
Jointer
