-17-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
J<
K
L
G
If, during the test run, you encounter an unusual noise
or vibration, stop using the machine immediately, then
review
KiflYc\j_ffk`e^
on
GX^\+)
for correction. If you
still cannot remedy a problem, contact our Tech Support
at (360) 734-3482 for assistance.
Kfk\jkilek_\dXZ_`e\#[fk_\j\jk\gj1
(
. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
)
. Ensure all tools and objects used during setup are
cleared away from the machine.
*
. Use the elevation handwheel to raise the planer/
moulder head to provide plenty of room for the safe
operation of the feed rollers and the cutterhead.
+
. Pull out the chip deflector retaining pin (
=`^li\
17
)
and remove the chip deflector.
,
. Wearing leather gloves, use a 14mm wrench to make
sure the knives are tight, and rotate the cutterhead
to make sure the knives do not hit the table.
-
. Reinstall the chip deflector, and connect the
machine to the power source.
.
. Push the OFF button in, then turn it clockwise so it
pops out (
=`^li\(/
) to ensure it resets.
/
. Turn the speed control dial (
=`^li\(/
)
counterclockwise to its slowest setting, then push
the ON button and the main motor will start.
0
. Turn the speed control dial clockwise to operate and
speed up the feed rollers.
('
. Press the OFF button to stop the machine.
((
. WITHOUT resetting the OFF switch, press the ON
button. The machine should not start.
— If the machine does not start, the OFF button
safety feature is working correctly.
— If the machine starts, immediately disconnect
the machine from power. The OFF button safety
feature is at fault and must be replaced before
using this machine.
K\jkIle
Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\
Zflc[ ZXlj\ j\i`flj \p\ `ealip
.
N\Xi
jX]\kp ^cXjj\j kf i\[lZ\ k_\ i`jb f]
`ealip
.
=`^li\(/
. Control panel.
=`^li\
17
.
Removing the chip deflector.
