international 21
Putting into operation
1
Make sure the place of setting up is clean, dry, and
well vented.
Warning:
As compressed air comes off the output, the out-
put may not be directed towards the operator or people
in the vicinity. The air coming off the exit may not be in-
haled. Daily check the pressure control valve.
Switching on and off the compressor
1
Check the model plate on the compressor: 230 – 240
V (or 110 – 120 V).
2
Plug the compressor cable into a standard socket (240
V or 120 V) and switch the compressor on.
3
For switching the compressor on, push the ON/OFF
switch (2) to
I
.
4
For switching the compressor off, push the ON/OFF
switch to
O
.
Operation
Fig. 4.1, 4.2
1
The pressure in the tank is controlled by the pressure
switch under the pressure switch cover. When the maxi-
mum pressure set is reached, the pressure switch is
activated and the motor switched off. The pressure is
reduced as the air is consumed by the connected tool,
until the minimum pressure set is reached. Then the
pressure switch re-engages the motor. The operator at
the compressor should take care that the motor engages
and disengages dictated by the influence of the increas-
ing and decreasing pressure in the tank. The motor
engages without any previous warning.
2
The maximum and minimum pressure have been set in
the works. These settings may not be altered.
3
All accessories get connected to the adjustable drain
valve (5).
4
As shown on the adjustable output pressure gauge (3),
the pressure of the adjustable exit can be altered by
turning the adjustable button (4).
Attention:
In order to read the correct output at the
output gauge, air must flow through the output. The
adjustable valve must be set and the pressure gauge
read with the valve open, while the air flows from the
output set through the accessory.
In order to increase the air pressure, turn the valve
clockwise. In order to reduce the air pressure, turn the
valve anti-clockwise.
Attention:
The absence of air flow during setting
produces an incorrect display. For a correct display, air
must flow.
5
Upon termination of your work, or when you leave the
compressor unattended, switch it off as follows:
•
Press the ON/OFF switch (2) to
O
.
•
Wait until the compressed air has escaped via the drain
valve (5).
Summary of Contents for 390 6106 000
Page 76: ...76 international...
Page 77: ...international 77...
Page 78: ...78 international...
Page 79: ...international 79...
