30
Dealer Service
MAN0764 (11/5/2008)
CROSSBAR REMOVAL
1.
It is necessary to gain access to bottom side of
cutter for crossbar removal. See Blocking Method
page 19.
NOTE:
You will need to use either the puller screw
(Item 6, Figure 14) or a small hydraulic jack to
remove the crossbar.
2.
Remove blades from crossbar as shown in Figure
13.
Figure 13
. Blade Removal
3.
Remove cotter pin from bottom of crossbar and
remove nut and washer.
4.
Refer to Figure 14
.
Attach a clevis (1) to each end
of crossbar, using blade pins, spacers, keyhole
plates, and blade pin clips.
5.
Position tube assembly (5) with threaded nut (4)
toward crossbar for puller screw removal or down
for hydraulic jack removal.
6.
For removal with puller screw, attach tube (5) to
each clevis with bolts (2) and nuts (3). Place pad
(4) in nut and thread puller screw (6) into nut from
bottom. Tighten until pad is solid against gearbox
shaft. For best results, strike head of puller screw
with a hammer while tightening with a wrench.
7.
For removal with a jack, attach tube to each clevis
with puller links (7), bolts (2), and nuts (3). Place
jack on tube with end of jack pressing against
gearbox shaft. Slowly apply force with jack.
NOTE:
Hydraulic jack will not operate if tipped
more than 90°. Use care to prevent bending cross
-
bar during removal.
Figure 14
. Crossbar Removal
7. Blade pin
8. Crossbar assembly
9. Shim, 18 ga
10. Shim, 20 ga
11. Keyhole plate
12. Blade lock clip
50. 1/2 NC x 1-1/4 HHCS GR5
1. Crossbar puller clevis
2. 5/8 NC x 4-1/2 Hex head cap screw
3. 5/8 NC Hex nut
4. Crossbar puller pad
5. Crossbar puller tube
6. Crossbar puller screw
7. Crossbar puller link
Summary of Contents for BATWING BW1620X
Page 50: ...50 Parts MAN0764 11 5 2008 MAIN FRAME ASSEMBLY FRONT SECTION Rev 9 1 2016...
Page 52: ...52 Parts MAN0764 11 5 2008 MAIN FRAME ASSEMBLY REAR SECTION Rev 4 5 2010...
Page 54: ...54 Parts MAN0764 11 5 2008 WING ASSEMBLY Right Wing Shown Rev 9 1 2016...
Page 56: ...56 Parts MAN0764 11 5 2008 WING CENTER GEARBOX ASSEMBLY...
