28
Dealer Service
MAN0764 (11/5/2008)
Gearbox Installation
(Figure 11)
NOTE:
Gearbox is heavy: do not attempt to move with
-
out mechanical assistance.
1.
Set gearbox on cutter and fasten with bolts and
nuts. Torque bolts to 300 lbs-ft.
2.
Attach crossbar (Crossbar Installation, page 31).
SPLITTER GEARBOX REPAIR
(Figure 12)
Splitter Gearbox Removal
1.
Disconnect and remove all drivelines from
gearbox.
2.
Remove the four cap screws and lock washers that
secure gearbox to cutter, and remove gearbox.
NOTE:
Gearbox is heavy: do not attempt to move it
without mechanical assistance.
Splitter Gearbox Disassembly
(Figure 12)
Center Shaft
1.
Remove plug from side of gearbox and pour out
the gear oil.
2.
Remove seal (6, to be replaced) from the front and
rear of the center shaft (5).
3.
Remove front cap (4) and gaskets (8, 9, 10) from
the front and rear of the center shaft (5).
4.
Support gearbox in a hand press and push on the
rear of the center shaft.
5.
Remove bearing cones (7), and gear (18) from
center shaft (5).
6.
Remove bearing cups (7) from housing and cap
using a punch and hammer.
Figure 12
. Splitter Gearbox Assembly
2. Lock washer, 10 mm
3. M10 x 1.5P x 30 Hex
head cap screw
4. Input cap
5. Input shaft
6. Input oil seal
7. Bearing assembly (cup
and cone)
8. Gasket .15 mm
9. Gasket .25 mm
10. Gasket .40 mm
11. Hub cap
12. Oil seal
13. Output shaft
14. Spacer
15. Shim .30 mm
16. Shim .40 mm
17. Shim .50 mm
18. Center gear
19. Wing gear
20. Bearing adjustment nut
21. 1/8 x 2-1/2 Cotter pin
22. Sealing washer
23. M18 x 1.5P Level plug
24. M18 x 1.5P Breather plug
Summary of Contents for BATWING BW1620X
Page 50: ...50 Parts MAN0764 11 5 2008 MAIN FRAME ASSEMBLY FRONT SECTION Rev 9 1 2016...
Page 52: ...52 Parts MAN0764 11 5 2008 MAIN FRAME ASSEMBLY REAR SECTION Rev 4 5 2010...
Page 54: ...54 Parts MAN0764 11 5 2008 WING ASSEMBLY Right Wing Shown Rev 9 1 2016...
Page 56: ...56 Parts MAN0764 11 5 2008 WING CENTER GEARBOX ASSEMBLY...
