Woodpeckers LED.D, Instruction Manual, Page: 14 / 24

12
indicator will be on when a mode is set.
8.1.1 Full power: the blue light radiates in full power.
8.1.2 Ramping mode: the blue light power increase stronger continually
and gets to the highest power 5 seconds later.
8.1.3 Pulse mode: the blue light works on the pulse condition.
8.2 Press the time button to set the solidifying time, 8 working times are
available: 5, 10, 15, 20, 25, 30, 35, 40 seconds.
8.2.1 Select 5 seconds: the blue light will shine at 1500 mw/
cm²~1700mw/cm².
8.2.2 Select 10, 15 , 20, 25, 30, 35 and 40 seconds: the blue light will
shine at 1000mw/cm²~1200mw/cm² .
8.3 When operating, aim the optical fiber at the correct position, press
the power button to start or stop emitting of the blue light.
8.4 During the operation, the blue light can be stopped by press the
power button at any time.
8.5 A battery detect circuit is fixed inside the main unit, when low power
is detected, the indicator of the main unit will wink, please charge in
time.
8.6 The mode indictor will be enlightened one by one when charging.
They will all be enlightened if charging has finished. If a battery error is
detected, the indicator of the mode will wink.
8.7 When the equipment is charging, it is possible to turn the equipment
into the normal work state by pressing any button. If the button is not
pressed within 10 seconds, the equipment will turn back into charge
state.
8.8 If the charge is not finished, when the working condition changes
from normal mode to sleep mode, the equipment will turn into charge
state automatically.
8.9 The equipment still can be used for a while after a low power alarm,
but with a lower light intensity. And then the equipment will turn into
the protect mode that all functions will be locked until the machine is
connected to the power supply or the battery is replaced.
8.10 When operation is finished, please clean the optical fiber with calico