woodmizer PH365, Instructions Manual

Page: 8 / 26

8
Setting using block
Loosen the screws with a wrench 10
mm. Just The screws should be in
lower position Tighten the screws
slightly so that the knife edges resting
tightly against the cutter.
Now, rotate the adjustment screws and
thus lifted steels.
Place the fixture on the cutter, as
shown. Adjust so that grades
downward
adjacent to the fixture when it is
pushed over the edge pressed against
kutterkroppen. Repeat on the opposite
page.
Check the position again and then lock
the screws.
Vertical cutters, No. 2 and 3
Spiders on the side cutters are 30 mm
in diameter, which is a standard. Thus
there is a wide selection of cutters
available.
At delivery, the machine is equipped
with two cutter heads in which you can
mount the molding knives or straight
steel. The top nut on the movable
cutter has a left winding.
Disassembly
Loosen the nut is 7.11 with a 30 mm
wrench and a wrench. Unscrew the nut
and remove the cutter head A and any
spacers.
Change of knives
Loosen the locking screw (B) with
Allen wrench (C) and remove the chip
breaker (D), then pry loose knives (E)
of the bolts (F).
Make sure you are using knives in the
right direction when they are
reinstalled. (The edge faces the chip
breaker.