10
30
- Screw the tank cap on firmly by hand.
Start on the unit
Do not start the unit until it has been completely assembled. Before switching on the unit, always
check the oil
Check before use!
Check the safe condition of the device:
– Check the device for leaks.
– Check the device for visual defects.
– Check that all parts of the device have been securely fitted.
– Check that all safety devices are in proper condition.
Once the machine has been set up properly, start the engine as follows:
1.
Press the fuel pump more than 10 times.
2. Turn the engine switch to the ON position.
3. Put the choke lever to the position
Danger of injury!
Do not operate the device unless you did not find any faults. If a part has
DANGER!
became defective, make sure to replace it before you use the device again.
Danger of injury!
Before starting work, always check the ground and remove all objects
DANGER!
which could be thrown by the device.
GB
31
4. Pull the recoil starter handle 3-5times to start the engine, as following picture.
The throttle trigger should be held on when starting.
5. Adjust the choke lever to the
position.
6. Pull the rope until engine starts. The throttle trigger should be held on when starting.
7. When the engine is running and idling, the throttle lever on handle is as below picture.
First press the lock off lever and then squeeze the throttle lever on, the machine will accelerate.
8. If using the Nylon cutter, before cutting, firstly bump it to feed the line.
GB
WDS_1133974_5pce_Multi Function_Manual - Woodies.indd 10
24/10/2017 11:23:31