28
Glue a set washer (#34) onto the ‘G’ end of the arbor so that 1/4" of dowel protrudes from the set
washer. (Note: this is the only set washer that is glued upon initial installation.)
Use 100 grit sandpaper to sand the two ends of the arbor until the arbor sizing jig (#56) can slide
completely onto both ends of the dowel. After this is achieved, use a succession of 150, 220, 400, and
600 grit sandings to smooth and polish the sections of the dowel that are shaded in the diagram on the
next page. Apply graphite to the shaded regions of the dowel by coloring those sections of the dowel
with a pencil
G
