PILOT AND BURNER FLAMES
VENTING SYSTEM
A qualified agency should examine the venting system annually.
Carefully reassemble and reseal
or servicing.
W
ARNING
FIREBOX CLEANING
1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
Make sure the gas valve is in the “OFF” position. Wait at least five (5) minutes before starting
maintenance.
Visually check pilot and burner flames periodically.
See Figure 3
5
for typical burner flame.
There is no air ad
j
ustment on the main burner. The air shutter is preset at the factory.
S
ee
Figure 36
for typical
pilot flame.
positions.
See pages
1
8
through 2
1
.
6.
Replace door (if it has been removed).
7.
Relight
the
pilot.
See page 2
4
.
8. Turn on main burners.
Figure 3
5
- Typical Burner Flame
Figure
3
6
- Typical Pilot Flame
W
ARNING
Any parts that need to be replaced must be
ordered from the manufacturer
.
Do not use
substitute materials.
Clean the ceramic glass periodically. Condensation will some-
times form on the glass during a cold startup. This is normal for
all gas fireplaces and inserts. This condensation often attracts
dust and lint to the surface of the glass. The initial paint curing
of the appliance can also leave a slight film on the glass. This
is a temporary problem.
Your should clean the glass after the first two weeks of use. After that, you should clean the glass no more than two or three times
Let glass cool before cleaning. Do not
clean glass when it is hot. Damage
could occur.
CLEANING GLASS
WAR
N
ING
a season. Use a mild glass cleaner to clean the door.
WARNING:Do not use abrasive cleaners. They will damage
the glass surface.
CLEANING AND MAINTENANCE
fireplace
properly after any cleaning
AIR SHUTTER ASSEMBLY
If necessary, change this by loosening nut and opening or
Air shutter is adjusted at
the
factory:
1/8"
for
natural
gas
and
1/4" open for
propane gas
closing the air shutter
slightly
more.
as a complete unit
NOTE: The glass frame assembly shall only be replaced
as supplied by the manufacturer (Part # A10003
7
).
40
