Woodbridge MONTEREY-(N, Installation And Operating Instructions Manual

Page: 5 / 48

4
L100001
5
PRODUCT FEATURES
AND
CODE APPROVAL
• This appliance has been certified
for use with either natural or
propane gas. See appropriate data
plates.
• This appliance is not for use with
solid fuels.
• The appliance is approved for bed-
room or bedsitting room installa-
tions.
• The appliance must be installed in
accordance with local codes if any.
If none exist use the current instal-
lation code. ANSI Z223.1/NFPA
54 in the USA, CAN/CGA B149
in Canada.
• This appliance is mobile home
approved.
• The appliance must be properly
connected to a venting system.
• The appliance is not approved for
closet or recessed installations.
PRODUCT SPECIFICATIONS
FIREPLACE CONTROLS
(see Figure 1)
1 - Hi/Lo Knob
2 - Off/Pilot/On Knob
3 - Remote Control Receiver
(optional)
4 - Blower Speed Control
5 - Blower
6 -Duplex Outlet for Blower (located against lower right outside wall)
6
Figure 1 - Fireplace controls
TESTED TO: ANSI Z21.88-201 4 /CSA 2.33-2014, CGA 2.17-M91 (R2009), CSA P.4.1-09 STANDARDS
LISTED VENTED GAS FIREPLACE HEATER
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
CODE APPROVAL
These appliances have been
listed
by OMNI and found to comply with the established standards for DIRECT VENT GAS
FIREPLACE HEATERS in the USA and Canada as follows:
1
2
3
4
5
This appliance may be installed in an aftermarket, permanently located, manufactured home
(USA only) or mobile home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate.
This appliance is not convertible for use with other gases, unless a certified kit is used.