Woodbridge BJ200, Installation And Care Manual

Page: 4 / 8

R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
4
4) Connect Power Supply:
Connect power supply to control unit. The electrical connections must comply with local
authority regulations and must be done by an authorized electrician.
5) Fill bathtub with water to approximately 40 mm(1.6˝) above the jets and trial run pump for
10-15 minutes. Check all the fittings for leaks and test the control functions. Switch off the
spa pump and leave the unit filled with water (pump is not running) for at least another two
minutes. Check the pump and pipes union connections for leaks. Hand tighten union
connections if required.
IMPORTANT: Your bathtub has been factory tested and approved. It is the responsibility of
the installer to test run the bathtub, check all the fittings for leaks and test the control functions.
NON OBSERVANCE WILL INVALIDATE FACTORY WARRANTY.
6) The unit must be connected only to a supply circuit that is protected by a Ground-Fault
Circuit Interrupter (GFCI). Such a GFCI should be provided by the installer and should be
tested on a routine basis.
3 ) Set the bathtub on two 4x4 pieces of lumber .so you can access from the bottom of the bathtub.