26
If
pilot does not
stay
lit, contact
a qualified
service
person
or gas supplier
for repairs.
Figure 9d - Remote Receiver Switch in ON Position
1.
Slide the remote
receiver
switch to the ON position.
This will allow the main burner
to ignite.
1.
Slide the remote receiver switch to the
OFF
position.
This will turn off the main burner.
levels by using the equipment
shutoff
valve.
from home for long periods of time. Heater may
come on automatically
with remote receiver
switch
i
n the "REMOTE" position.
TO TURN OFF GAS
TO APPLIANCE
1.
Tum off all electric power to
the
appliance
if service
is to be
performed.
Unplug
DC
adapter
from
the
power
outlet.
2.
If
necessary,
remove access panel from the appliance
to access manual
shutoff
valve on gas line.
3.
Turn
the
gas control
manual
valve clockwise
to the
full OFF position.
4.
If
necessary
, r
eplace
media tray or a
ccess panel
REMOTE CONTROL
OPERATION
Initializing the System for the First Time
1.
Install the
4
AA batteries
into the receiver
batter bay.
Note the polarity
of the batteries
and insert into the
battery
bay as indicated
on the battery
covel' (+/-).
2.
Place the 3-posilion
slider switch
i
n
the REMOTE
position.
3.
Insert
the end of a paper
clip into the hole marked
PRG on the receiver
front
cover. The receiver
will
beep three
times to indicate
that it is ready to syn-
chronize
with a transmitter.
4.
Install the
3
AAA batteries
in the transmitter
battery
bay located
on
the
base of the transmitter.
5
.
Press
the ON
button
on the transmitter.
The receiver
will beep
four times to indicate
the
transm
i
tters
Temperature Indication Display
1.
With
the system
in the OFF
position,
press
the
THERMOSTAT
key and the MODE key at the same
time.
CAUTION: Do not try to adjust
heating
WARNING: Make sure the remote receiver
switch is in the OFF position when you are away
Fig. 1:
Proflame Transmitter.
Blue LCD display
ON/OFF Key
THERMOSTAT Key
UP/DOWN Arrow
KeyMODE Key
Manually
Turning ON the Appliance
Manually
Turning OFF the Appliance
command
is accepted.
The system
is
now
initial-
ized.
2.
Look at the LCD screen
on
the transmitter
to verify
that
a °C or
°
F is
visible
next
to
the room temperature.
Figure
47
d
- Remote Receiver Switch in OFF Position
OPERATING INSTRUCTIONS
3
8
