Switch to function mode, and
then wash after 3 minutes
Troubleshooting Guide
Problem
Cause
Solution
No flushing
Water supply hose buckling
causes block
Fill valve is off
Water supply is cut off
Poor flushing
Water supply hose buckling
causes partial block
Fill valve is not fully turned on
Filter is dirty and causes block
The water is not hot
The water temperature is setted
on normal temperature level
Solve the buckling
Turn on the fill valve
Connect water supply and
wait for the water
Solve the buckling
Turn on the fill valve fully
Clean the filter
Reset the water temperature
Seat temperature
is not hot
The seat temperature is setted
on normal temperature level
In standby mode
Reset the seat temperature
Shift to function mode for
3 minutes
No wind out
Spray wand
cannot retracted
Spray wand
cannot stretch out
Controller cannot
display
The wind temperature is setted
on normal temperature level
In standby mode or power
save mode
Power off
Get stuck by impurities
Do not sit in sensing area
Reverse the polarity of battery Reload the battery
Sit right in the sensing area
Push back the wand lightly and
wait for the power
Clear away the impurities
Push back the wand lightly and
wait for the power
Shift to function mode to use
dry function
Reset the wind temperature
Power off
In standby mode or power
save mode
Wind temperature
is not hot
Caution
If the problems cannot be solved as per above methods,
please shut-off the power, and contact service providers for
maintenance.
If the leakage circuit breacker often trips off, it means the
products has electricity leakage, so please shut-off the
power, and contact service provider for maintenance.
12
