PRODUCT ASSEMBLY
1. Remove Burner Assembly,
and Burner Media from packa-
ging (see
Parts List
)
2. Connect the Burner Assembly
to gas supply using supplied
flex connector and shutoff
valve.
3. Evenly fill the media
compartment with burner
media (broken tempered
glass) fully covering the
burner as shown on a picture.
If you are NOT planning to
add optional topping media,
then
fill
the
media
compartment in full and
proceed to the step 5.
4. Place and evenly distribute top-
ping media (optional logs or sto-
nes) on top of burner media as
shown on a picture.
5. Carefully leak test all
connections following the
These
plates
contain
important information.
NOTICE: Installation and
repair should be done by a
qualified service person. The
appliance
should
be
inspected before use and at
least annually by a qualified
service person. More fre-
quent cleaning may be
required as necessary. It is
imperative
that
control
compartment, burner and
circulating air passageways
of the appliance be kept
clean.
WARNING: Failure to position
the parts in accordance with
these diagrams or failure to
use only parts specially
approved with this appliance
may result in
property
damage or personal injury.
6. Having free access to the valve
light
the appliance
Make sure the flame covers the entire burner surface as shown.
following the
procedure on
attached to the fireplace.
CAUTION: Do NOT remove
the
metal
data
plates
INSTALLATION
6
procedure on Page
7
.
Page
9
.
CAUTION: When using lava rock or basalt stones as a
topping media, keep the area in front of the pilot screen
at least
2" clear of topping media. Blocking the pilot
screen can cause
improper operation!
