Troubleshooting Guide
Power Feed Problems
Troubleshooting Guide
60HDdoc011304
6-6
6
PROBLEM
CAUSE
SOLUTION
Power Feed Motor Overheats.
Middle track oiler is dragging.
Clean and lubricate the middle
track oiler. Allow motor to cool
before restarting.
Ground is not level.
Level the sawmill. Allow motor to
cool before restarting.
Track roller bearing drag is
excessive.
Replace the roller. Allow motor
to cool before restarting.
Chain is dragging.
Make sure chain is centered on
idler; Clean and lubricate chain;
Adjust chain tension. Allow
motor to cool before restarting.
Chain is improperly tensioned.
Adjust chain tension. Allow
motor to cool before restarting.
Operator Seat option load is
excessive.
Check seat bearings for freedom
of movement; Loosen clamping
screw 1/4 turn. Allow motor to
cool before restarting.
Power feed is binding.
Adjust belt tension; Check condi-
tion of belt, pulleys, bearings,
and sprocket; Check motor for
ground fault. Allow motor to cool
before restarting.
Saw head load is excessive.
Avoid unnecessary modifications
to saw heads that would give
them extra weight. Allow motor
to cool before restarting.
Blade is dull or improperly set.
Use proper blade maintenance
procedures (See Sharpener or
Toothsetter manual). Allow
motor to cool before restarting