Sawmill Operation
Blade Guide Arm Operation
4
4-8
60HDdoc011304
Sawmill Operation
4.4
Blade Guide Arm Operation
1.
Look down the length of the log to see its maximum width. The outer blade guide should
be adjusted to clear the widest section of the log by less than 1" (25.4 mm).
2.
Use the blade guide toggle switch on the control panel to adjust the outer blade guide as
necessary. Push the switch to the left to move the arm in. Push the switch to the right to
move the arm out.
See Figure 4-3.
3.
Use the blade guide toggle switch to readjust the outer blade guide as you are cutting in
order to keep the guide within 1" (2.5 cm) of the log. Be sure to adjust the arm back out
before returning the carriage.
FIG. 4-3
3H0279
Blade Guide
Arm
In
Blade Guide
Arm
Out
