Safety & General Information
Sawmill Maintenance
Safety & General Information
HDSdoc020719
1-3
1
sawmill. Failure to do so may result in serious injury or death.
WARNING!
Always make sure log is clamped securely before sawing.
Failure to do so may result in serious injury or death.
WARNING!
Use ONLY water or alcohol solution with the water lube
accessory. Never use flammable fuels or liquids. If these types of
liquids are necessary to clean the blade, remove it and clean with a
rag. Failure to do so may result in serious injury or death.
CAUTION!
Be sure the log clamps are all the way down before loading
a log onto the bed. Failure to do so may result in machine damage.
CAUTION!
Before loading a log, be sure the cutting head is moved far
enough forward so the log does not hit it. Failure to do so may result in
machine damage.
CAUTION!
Do not try to force the saw head beyond its upper and
lower travel limits. Damage to the up/down system may result.
CAUTION!
Be sure to stop the blade when returning the carriage. This
will not only prevent the blade from being pulled off and ruined by a
wood sliver, but also will increase the life of the blade.
CAUTION!
The saw head will hit the spring-loaded ramp stops when
adjusted for low cuts. Remove the loading ramps before sawing to
prevent damage to the saw head and/or blade guide arm.
CAUTION!
Never clean the blade or the blade wheels with a brush or
a scraper during sawmill operation.
CAUTION!
Before installation of the blade, inspect it for damage and
cracks. Use only properly sharpened blades. Always handle the blade
with extreme caution. Use suitable carrier equipment for transporting
the blades.
CAUTION!
Blade should be replaced every two hours of sawmill
operation.
CAUTION!
Always wear gloves when handling the blade. Never grab
the blade with bare hands!
CAUTION!
If the blade breaks during sawmill operation, push the
EMERGENCY STOP button to stop the blade motor and wait 10
seconds before you open the blade housing cover.
CAUTION!
The sawmill’s work-stand should be equipped with a 4 kg
or bigger dry powder extinguisher.
1.5
Sawmill Maintenance
Summary of Contents for LT15SC M2 E11S
Page 1: ......
Page 2: ......
Page 120: ...Track Roller Distance Adjustment 6 6 17 HDSdoc020719 See Figure 6 18 FIG 6 18 0 5 mm 1 2 3...
