Blade Guide Spacing
6
6-11
HDSdoc020719
3.
Measure the distance from the bed rail to the bottom of the tool.
4.
Move the carriage so that the front end of the tool is positioned above the bed rail.
5.
Measure the distance from the bed rail to the bottom edge of the tool.
6.
Loosen one set screw at the side of the blade guide assembly.
7.
Use the set screws shown to tilt the blade guide until the measurement from the bed rail to the tool
equals the first measurement taken at the center of the tool.
See Figure 6-12.
8.
Move the carriage forward so the back end of the tool is over the bed rail.
9.
Use the set screws shown to adjust the blade guide tilt until the measurement from the bed rail to the
tool equals the other two measurements taken.
10.
Move the tool close to the other blade guide and repeat the previous steps.
NOTE:
If major adjustments to blade guide tilt were made, remeasure the distance between the
blade and the bed rails to ensure the correct 1/4" (6.5 mm) blade guide deflection. Adjust if
necessary.
6.10 Blade Guide Spacing
HINT:
When adjusting blade guide spacing, loosen the top set screw and one side set screw only.
This will insure horizontal and vertical tilt adjustments are maintained when the set screws are
retightened.
1.
Adjust the inner blade guide so the blade guide flange is approximately 1/16" - 1/8" (1.5 - 3.0 mm)
from the back of the blade.
FIG. 6-12
SM0070
Loosen jam nuts and turn screws
to tilt roller up or down
Loosen jam nuts and turn screws
to tilt roller up or down
Summary of Contents for LT15SC M2 E11S
Page 1: ......
Page 2: ......
Page 120: ...Track Roller Distance Adjustment 6 6 17 HDSdoc020719 See Figure 6 18 FIG 6 18 0 5 mm 1 2 3...
