Sawmill Setup
Tensioning The Blade
3
3-6
1597doc111810
Sawmill Setup
3.3
Tensioning The Blade
See Figure 3-4.
The blade tensioner is factory-set so proper blade tension is achieved
when the rubber spring is compressed 3/16” (4.8 mm). A 3/16” washer is provided to indi-
cate when the rubber spring has been compressed properly. To tension the blade, turn
the blade tension handle clockwise to compress the rubber spring until the indicator
bracket is even with the outside face of the washer. Check the blade tension occasionally
when adjusting the cant control or while cutting. As the blade and belts heat up and
stretch, the blade tension will change. Adjust the tension handle as necessary to keep the
bushing aligned with the indicator.
NOTE:
When the tensioner components are together before the spring begins to com-
press, the indicator bracket should be even with the inside face of the washer. Loosen the
indicator mounting bolt and adjust the indicator even with the inside face of the washer if
necessary.
FIG. 3-4
150018B
Blade Tension
Handle
Outside face
of washer even
with indicator
Rubber
Spring
Blade Tension
Indicator
