Sawmill Setup
Carriage Side Adjustment
Sawmill Setup
doc072619
4-2
4
9.
Measure the distance from the bed rail to the bottom of the blade near the outside blade guide.
When the blade is parallel to the bed, it will measure the same distance from the bed rail at the
inside and outside of the saw head.
LEVELING THE SAWHEAD
1.
Turn the saw head tilt adjustment nut clockwise to raise the outside of the saw head.
2.
Turn the nut counterclockwise to lower the outside of the saw head.
3.
After the saw head is adjusted parallel to the bed rail, check the space between the uppermost
mast bearing and mast rail.
4.
Adjust as necessary so the space is 1/32” - 1/16” (0.8 - 1.6mm).
See Figure 4-2.
4.2
Carriage Side Adjustment
The carriage rests on two roller bearings on the rail edge. Two bearings on either side of the
roller bearing can be adjusted to keep the carriage tight against the rail.
FIG. 4-2
150125-10
Turn Tilt Adjustment Nut
Clockwise to raise outside of
saw head; Counterclockwise
to lower outside of saw head
Loosen Bearing Nut
And Adjust Space from
Mast to 1/32" - 1/16"
(0.8 - 1.6mm)
