Sawmill Assembly
Leg Assembly
Sawmill Assembly
doc072619
3-3
3
See Figure 3-4.
NOTE:
Bed sections weight approximately 160 lbs. Use at least two people to
move them.
12.
Set the bed sections on a level surface.
3.2
Leg Assembly
1.
Place a hex nut on each leg approximately half way down the shaft.
2.
Slide the outrigger (nut keeper) plate into the mounting bracket.
3.
Position the square nut between the plate and the bracket.
4.
Thread each leg through the bracket, the square nut, and the plate. (See FIG. 3-2.)
5.
Tighten the hex nut around the leg bracket (requires 1 5/16” wrench).
6.
Assemble four legs to each bed section.
FIG. 3-4
Shipping bolts (x4)
Shipping strap (x2)
