22
13.
COMPLETION OF FRONT INSTALLATION & FINAL REVIEW
13.1
FIT FIR FRONT CASTINGS
Fit the fire front casting to the front surround. Locate the two screw heads at the
rear top corners of the casting through the keyhole slots at the inner sides of the
surround. If the screw heads do not project enough or project too far, the screws
can be adjusted. Lower the casting so that it rests on the hearth (see figure 37).
Place the bottom front cover casting in position below the fire front casting.
13.2
FINAL REVIEW
13.2.1
Recheck the operation of the fire at all control positions.
13.2.2
Visually inspect the appliance. Clean off any marks incurred during
installation.
13.2.3
If a gap is visible between the inner sides of the front surround and the
ceramic sidewalls, gently slide the walls forward.
13.2.4
Advise the customer that they should read their Owner’s guide before operating
the fire and always follow the advice in the section headed “Cleaning your fire”.
13.2.5 Stress
that no
extra coals must be added over and above those supplied with the
appliance and that any replacements must only be the authorised spares. Warn that ignoring
this advice could cause incomplete clearance of the products of combustion with consequent
health hazards.
13.2.6
Advise the customer that the appliance will operate to its maximum potential if
the flue is primed during the first 20 – 30 minutes of use. To do this, simply slide the
control to its highest setting. This will also burn off any carbon deposits that may have
formed during previous use.
If using the appliance for long periods it is beneficial to change between settings. This
will also help to remove any carbon deposits that may form during use.
This is explained in the Owner’s manual under the section ‘Operating the Fire’.
13.2.7
Advise the customer how to operate the appliance. Point out that lighting
instruction details are contained on a plate tied to the bottom of the appliance (leave the
plate visible in front of the bottom front cover as a reminder).
13.2.8
Recommend that the appliance should be serviced and the chimney inspected by
a competent person at least annually.
13.2.9
Hand this guide and the owner’s guide to the customer.
Fig. 37 Fire Front Casting Location
Summary of Contents for Marseille BR622
Page 9: ...9 Fig 6 Pack Contents...
