18
10.
FRONT SURROUND & CONTROL LINKAGE INSTALLATION
10.1
Remove the tape securing the control linking bar to the front surround.
Slide the control button upwards as far as it will go. Make sure that the bottom of the
linking bar is higher than the bottom of the front surround.
10.2
Carefully lift the front surround.
Do not lift it by the control button.
Place the
front surround against the fireplace front surface so that the two retaining plates at
the back of the surround are directly above the two upper retaining brackets at the
top of the convection box. Lower the surround unit making sure that the retaining
plates locate fully over the brackets on the convection box (See figure 26).
Swing the bottom control linking bar towards the centre of the fire to clear the
right side of the surround. Slide the surround unit sideways, if necessary, to align
the bottom fixing holes with those in the convection box.
10.3
Fix the bottom of the surround unit to the convection box with two
screws (See figure 27).
10.4
All Surrounds
Align the hole near the bottom of the control linking bar with that in the control
pivot bracket. Join them with the knurled shouldered screw (See figure 28). Make
sure that the isolating valve is closed. Slide the control button fully from top to
bottom and back to make sure that the slide and pivot mechanisms move
smoothly. Note that some resistance should be felt when the slide button reaches
the “burner fully on” position.
Fig. 28 Control bar & pivot bracket
Fig. 27 Front Surround Bottom
Location
Fig. 26 Front surround top location
Summary of Contents for Marseille BR622
Page 9: ...9 Fig 6 Pack Contents...
