62
3.5.1 VLAN SETTING
To configure 802.1Q VLAN and port-based VLANs on the WoMaster switch, use the VLAN Settings page to configure
the ports. , User can assign Management VLAN, create the static VLAN, and assigns the Egress rule for the member
ports of the VLAN.
The description of the columns is as below:
TERMS
DESCRIPTION
Management VLAN ID
Default : 1
.
The switch supports management VLAN. The management VLAN ID is
the VLAN ID of the CPU interface so that only member ports of the
management VLAN can ping and access the switch.
Static VLAN
User can assign a VLAN ID and VLAN Name for new VLAN here.
VLAN ID
Default: 1
Used by the switch to identify different VLANs. Valid VLAN ID is
between 1 and 4094.
Name
A reference for network administrator to identify different VLANs. The
available character is 12 for User to input. If User don’t input VLAN
name, the system will automatically assign VLAN name for the VLAN.
The rule is VLAN (VLAN ID).
The steps to create a new VLAN: Type in VLAN ID and NAME, and press
Add
to create a new VLAN. Then User can see
the new VLAN in the Static VLAN Configuration table. After created the VLAN, the status of the VLAN will remain in
Unused until User adds ports to the VLAN.
NOTE:
1.
Before User changed the management VLAN ID by Web and Telnet, remember that the port
attached by the administrator should be the member port of the management VLAN;
otherwise the administrator can’t access the switch via the network.
2.
WoMaster switch supports max 256 groups VLAN.
