Wolturnus Active Wheelchair Manual 2019
Adjustment and set-up
6.10 Seat angle adjustment, standard
The seat can be angled from 0 to 30 degrees using one or two gas dampers.
•
Turn off antitip. This ensures that the chair does not tip backwards if the seat is angled too
much.
•
The angle of the seat can now be adjusted by holding the release lever (Fig. 24) at the bot
-
tom while lifting up or pushing down on the push handle.
•
When the desired angle has been found, release the lever to lock its position.
When adjusting the seat angle, the center of gravity of the wheelchair can be displaced and
the risk of tilting backwards can be increased. After adjusting the seat angle, check the cen
-
ter of gravity and adjust if necessary before using the wheelchair (see section 6.12).
WARNING!
Risk of crushing hazard.
Avoid holding the gas damper while adjusting the seat angle. This may cause your fingers to
clamp.
WARNING!
Fig. 24 Hold down the release lever
Fig. 25 Adjust seat angles
22
Summary of Contents for Dalton
Page 2: ......
Page 49: ...Wolturnus Active Wheelchair Manual 2019 A Run 49 ...
