Wolfgang Puck BKMT0020, Use And Care Manual

Page: 6 / 16

Disassembly and Assembly of
Attachments
Disassembly and Assembly of
Attachments (cont.)
Mixing Bowl
The Mixing Bowl ships with the Drive Shaft already attached. It can be
disassembled for cleaning.
Optional Bowl Scraper
The Bowl Scraper can be used in conjunction with the assembled Whisks
or Paddles. It is not designed to work with the Dough Hook. The Bowl
Scraper comes with the Bowl Scraper fully assemble and mounted onto
the Twin Assembly.
Dough Hook
Paddles/Wire Whisk Attachment/Twin Assembly
Your Mixer ships with the Wire Whisks already attached to the Twin
Assembly Cover. It can be disassembled for cleaning.
Assembly
Assembly
Assembly
Disassembly
Disassembly
Disassembly
Turn the Mixing Bowl upside down grasp the bottom of the Drive
Shaft and turn counter clockwise until it stops. Figure 1
Push the top of the Drive Shaft from inside the Bowl through the
opening in the bottom of the bowl. Figure 2
1
2
To remove the Bowl Scraper from the Twin Assembly, use gentle
force by pulling the side clips on the Bowl Scraper outward until
they pop off of the Twin Assembly Cover. Figure 12
Pull the Bowl Scraper off the Twin Assembly by turning at an angle
to remove.
1
2
The Dough Hook comes with a center attachment that pushes the
dough away from the Drive Shaft during mixing. To remove, hold
the Dough Hook while turning the Pusher clockwise until it stops.
Pull the Pusher away from the Dough Hook. Figure 14
1
Turn the Mixing Bowl upside down and slide the Drive Shaft through
the center hole from the bottom of the Bowl. Figure 3
Turn the Drive Shaft until is nests flush with the bottom of the bowl,
then rotate clockwise until it stops. Figure 4
Turn the Drive Shaft clockwise until it stops
Place the Mixing Bowl on top of the Motor Housing and apply slight
downward pressure while turning clockwise until it stops. Figure 5
1
2
3
4
Place the Scraper Assembly over the top of the Twin Assembly
Cover and press down until both sides of the Scraper’s side clip
click into place over the Twin Assembly Cover. Figure 13
1
Line up the tabs on top or the Pusher with the receptacles on the
Dough Hook and push straight until it is nested in the receptacle,
turn counterclockwise until and stops to lock it in place (Figure 15).
Place the assembled Dough Hook over the Drive Shaft in the Mixer
Bowl. You may need to turn the assembly until it drops down onto
the Drive Shaft.
1
2
Assembly
Disassembly
Turn the Twin Assembly over.
While holding the Twin Assembly pull the selected attachments off
the Spindle. (Paddles or Whisks). Figure 6
Once both attachments are removed from the Spindle the Gear will
lift straight out of the Twin Assemble Cover. Figure 7
Remove the Spindle Assembly from the Twin Assembly Cover by
using gently force to pull the sides of the Twin Assembly Cover
outward until the Spindle pops up. Lift out of Twin Assembly Cover
(Figure 8).
1
2
3
4
Turn the Twin Assembly cover over and place the Spindle into
the Twin Assembly Cover by pressing down until both sides have
clicked into place (Figure 9).
Place the Gear over the center ring of the Spindle attachment (the
Gear will not lock into place over the ring, it is held in place once
you add the Paddle or Wire Whisk to the attachment). Figure 10
Select either the Paddles or Wire Whisk. Place the selected
accessory onto the Spindles and push down until you feel them
click into place. Figure 11
1
2
3
9 10