17
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de
4.4 Working note
WARNING!
Before carrying out any work on the power tool, remove
the battery from the device. Unpack the strip cutter before
putting it into operation and check that the delivery is com-
plete and that there is no transport damage.
NOTE
The batteries are not fully charged on delivery.
Fully charge the batteries before using them for the fi rst
time. Refer to the operating instructions of the charger.
4.5 Inserting/changing the battery Figure E+F
► Charged battery until fully charged
Push the catch into the power tool
► To remove the unlocking buttons
Press (1.) and pull out the battery (2.).
CAUTION!
When not in use, disconnect the contacts of the battery
protect. Loose metal parts can short-circuit the contacts,
there is danger of explosion and fi re!
4.6 Battery charge status Figure G
► By pressing the button, the battery status LED can be
used to check the battery charge status.
► The display goes out after 5 seconds.
If one of the LEDs fl ashes, the battery must be char
ged. If no LED lights up after pressing the button, the
battery is defective and must be replaced.
4.7 Using rechargeable batteries
► Only use original batteries with the capacity indicated
on the type plate of your power tool. Voltage. If other
batteries are used, e.g. imitations, reconditioned batte
ries or batteries from other manu facturers, there is a
risk of injury and damage to pro perty.
Damage caused by exploding batteries.
► Only charge the batteries with chargers recommended
by the manufacturer. Using a charger suitable for a
specifi c type of battery, there is a risk of fi re if it is used
with other batteries is used.
► The battery can be damaged by pointed objects such
as nails or screwdrivers or by external force. An
internal short circuit may occur and the battery may
burn, smoke, explode or overheat.
► For marking the power tool
only use adhesive labels. No holes
into the housing.
► Spindle lock only when stationary
Press grinding tool.
4.8 Clean the dust fi lter regularly Figure H
► Remove the dust fi lter and clean it with dry
Blow out compressed air.
5.0 Transport
To avoid injuries and damage to the device, a case or
cardboard box must be used during transport.
6.0 Maintenance
► Before carrying out any work on the power tool,
disconnect the mains plug from the socket or the
battery from the device.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean. The machine
must then be sent to an after-sales Service agent.
Addresses are listed in the Section “After- sales
service and customer assistance”.
► The motor is equipped with shut-off charcoal which
shuts off the motor when the wear limit is reached.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine.
6.1 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
EN
