16
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de
Additional safety warnings
Wear safety goggles.
Noise/vibration information
Wear hearing protection.
Measurements determined in accordance with EN
60745
The A-rated sound pressure level of the machine is
normally
Sound pressure level .........................dB(A) 83,8
Sound power level..............................dB(A) 94,8
Margin of error ..................................K=d +/- 1.5 dB
Wear hearing protection!
Overall vibration values
(vector sum of three directions)
determined in accordance with EN 60745:
Vibration emission level .....................ah = <2,5 m/s²
Margin of error .....................................K = +/- 1.5 m/s²
3.0 Preparation of the machine
The AKKU strip cutter 18V is largely maintenance-free.
3.1 Installing and changing the saw blade (Fig. B)
Remove the battery from the machine before starting to
change the saw blade ! For your own safety use wor-
king gloves.
Before installing the saw blade, make sure that the clam-
ping fl ange and the saw blade are clean.
Always make sure that the saw blade is sharp and in good
condition.
Dull saw blades lead to poor work results. Smoke may be
generated during cutting and the machine may be overloa-
ded.
3.2 Removing the saw blade
► Loosen the four screws (4) with an Allen key
► Remove the cover
Press the spindle lock (3) and loosen the clamping nut
(5) with a two-hole spanner
► Remove the saw blade.
3.3 Installing the saw blade
► Place the saw blade on the clamping fl ange,
Direction of rotation of the saw blade counterclockwise.
► Press the spindle lock and tighten the clamping nut in
Tighten clockwise.
► Mount the cover with the 4 screws and lock washers.
► The machine must not be operated without the protecti
ve device (cover) fi tted.
If it is damaged or defective, it must be replaced.
4.0 Operation
4.1 Commissioning Figure D
► Adjust the stop (1) to the desired strip width.
► Fix stop with knurled screw (2).
► Place machine on material web and switch on.
► Pull the machine along the material web with an even
tension.
4.2 Operating Instructions
► Switch on picture C
Short time operation without engagement
Push the switch rocker forward (1 )and hold it.
Release the switch rocker to switch off .
► Switch on Figure C
Continuous operation with engagement
Push the switch rocker forward (1.)
and engage by pressing the front end (2.).
► Switch off Figure C
To switch off the rocker switch ( 3 ) by
Release the pressure on the rear end.
4.3 Application
The Akku Strip Cutter 18V is designed to cut skirting strips,
fl ooring friezes and stair coverings made of lino and vinyl.
EN
