Sealed Burner Rangetop Installation
13
wolfappliance.com/specs
Gas Supply Connection
IMPORTANT NOTE:
All connections to the gas piping must
be wrench-tightened. Do not make connections too tight,
this may crack the regulator and cause a gas leak. Do not
allow the pipes to turn when tightening fittings.
Assemble the flexible metal connector from the gas supply
pipe to the gas pressure regulator. Determine the fittings
required depending on the size of your gas supply line,
flexible metal connector and shut-off valve. Refer to the
illustration below. If a flexible metal connector is used, be
sure the tubing is not kinked. Open the shut-off valve in
the gas supply line. Wait a few minutes for the gas to
move through the line.
GAS LEAK TESTING
Brush a liquid detergent solution onto all gas connections
to test for leaks. Bubbles around connections will indicate
a gas leak. If a leak appears, close the gas shut-off valve
and adjust connections. Check for leaks again. Clean off
the detergent solution.
Never test for a gas leak with a match or other flame.
FLEXIBLE
METAL CONNECTOR
ELBOW
ADAPTER
ADAPTER
SHUT-OFF VALVE
NIPPLE
BOTTOM OF RANGETOP
Gas supply line connection.
Before connecting the gas supply, make sure all valves
are in a closed position.
Install the Rangetop
Prepare the finished opening for the rangetop according
to dimensions shown in the illustration for your specific
model on the previous pages. The platform must be
3
/
4
"
(19)
thick and include a cut-out at the right rear for electri-
cal and gas supply connections.
IMPORTANT NOTE:
The platform must be level to ensure
that the cooking surface is level.
Remove and discard all packing materials from the
rangetop.
If your installation requires a riser, it must be attached to
the rangetop before installation. Refer to the installation
instructions packaged with the riser.
Position the rangetop on the platform. Electrical and gas
supply connections should be made before the rangetop
is placed in its final position.
