Drawer Microwave
(Models MWD24-2 / MWD30-2)
Component Removal
4-12
#813632 - Revision B - December, 2009
Figure 4-16. Auto Drawer Gear Mounting Screws
Screws
Auto Drawer Gear Removal/Installation:
NOTES:
•
This procedure requires a 14" or greater phillips
screwdriver.
•
The MWD
30-2
auto drawer gear can be pulled
straight out, after removing screws holding gear to
cavity.
1.
Disengage any power going to the unit.
2.
Open the drawer and keep it open.
3.
Remove the top cover and right side cabinet.
4.
Unhook wiring to auto drawer gear.
5.
Remove the bottom screw from below the auto draw-
er gear (See Figure 4-15).
6.
Extract four (4) mounting screws holding the auto
drawer gear to the bottom cavity angle (See Figure
4-16).
7.
Disengage (pull) the auto drawer gear from rack
gear and slide to the right (toward the rear), then
turn motor 90° and slip out along the rear of the
drawer.
8.
Then tilt auto gear motor 20° to remove the assem-
bly. The auto drawer gear is now free.
Installation:
1. Proceed in reverse to reinstall the auto drawer gear
taking care that the gear teeth are set into the cavity
angle correctly.
Figure 4-15. Auto Drawer Gear Screw Removal
Bottom of Unit
Screw
Auto Drawer
Gear