Page 23
4
Remove the burner assembly from the unit.
Burner Cap
Burner Assembly
Igniter
Electrode Wire
Remove the Burner Pan
Lift the burner pan from the burner box.
Remove the Regulator
1
Disconnect the external gas supply line to the inlet of the
regulator from the
1
/
2
” NPT nipple.
2
Use a
5
/
8
” combination wrench to remove the regulator
outlet line from the brass fitting.
3
Use a
1
/
4
” combination wrench to remove the retaining nut
from the regulator bracket.
4
Remove the regulator and regulator bracket from the unit.
5
Use a
7
/
8
” box wrench to remove the brass fitting from the
regulator outlet.
TIP: The regulator is identified as liquid propane (LP) by its red
cap.
REGULATOR INSTALLATION
Install the Regulator
1
Use a
7
/
8
” box wrench to install the brass fitting onto the
regulator outlet.
2
Place the regulator and regulator bracket in the unit.
3
Use a
1
/
4
” combination wrench to install the retaining nut
into the regulator bracket.
4
Use a
5
/
8
” combination wrench to install the regulator outlet
line onto the brass fitting.
5
Connect the external gas supply line to the
1
/
2
” NPT nipple
on the inlet of the regulator.
WARNING
Only pipe thread compound should be used. Do not
use Teflon tape to seal gas connections.
Install the Burner Pan
Place the burner pan on the burner box.
Install All Burner Assemblies
To install each burner assembly:
1
Attach the electrode wire to the igniter.
2
Place the burner assembly into the burner pan.
3
Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
CG Professional Gas Cooktop Service Manual
REMOVE ALL BURNER ASSEMBLIES (continued)
service.subzero.com
828386 REV. A 06/2018
22
