12
3062815_0110
9. Rooftop installation (interlocking tile,
plain tile) collector installation
Note:
Some tile shapes (e.g. flat tiles that are profiled at the top and bottom) must be cut out in the area of the roof
hooks to enable the fitted roof hooks to lie correctly and to prevent the tile above from lifting up.
Extension of the mounting rail
from 4 collectors
If more than 3 collectors are fitted, extend the mounting rails in accordance
with the diagram.
One of the three screws can also be used to secure the collector to a roof
hook. For this, the channel rail remains aligned in the centre; the screw can be
manoeuvred via the slot into the correct position above the hook.
Combination
screw
M8x20
Grub screw
M8
Washer
nut M8
Mounting rail,
e.g. for 3 collectors
Mounting rail, e.g. for
2 additional collectors
Mounting rail
joining set
3 coach bolts M8 x 25 with washer nuts M8
1.
Insert the collector with the grub screws first into the lower mounting rail according
to the diagram and initially secure it by hand with the M8 washer nut.
2. Push the combination screws M8x20 through the top mounting rail and
initially tighten by hand into the collector.
3. Fit additional collectors likewise.
4. Secure the fittings for the flow and return. Check gaskets.
5. Tighten all screws and nuts to secure the collector.
- Are all gaskets in place?
- Maintain the necessary clearance
- Align all threaded fittings
-
Counterhold
with a second
open-ended spanner
(max. torque 20 Nm.)
NB
