14
Safety instructions
Operating the unit
Never start the unit and never leave it running in a closed
room or building. The inhalation of exhaust gases may
be fatal. Use the unit outdoors only.
Wear eye and ear protection when using the unit.
If working in a dusty environment, wear a face
or dust mask. A long-sleeved shirt is recommended.
Wear thick, long trousers, boots and gloves. Do not wear
loose clothing, jewellery, short trousers, sandals and do
not walk barefoot. Pin your hair above your shoulders.
The cutting attachment guard must always be attached
when the unit is being used as a lawn trimmer.
Both trim lines must be pulled out and the correct line
must be installed. The trim line must not be pulled out
over the end of the guard.
The unit has a clutch. The cutting attachment stops
when the unit is running at no load. If it does not stop,
have the unit adjusted by a mechanic at your authorised
dealer.
Before switching on the unit, ensure that the line
spool/cutting blade cannot strike an object.
Adjust the handle bar to your height so that the you have
the unit under control.
Do not touch the cutting attachment on the unit.
Operate the unit in daylight or adequate artificial lighting
only.
Avoid starting the unit unintentionally.
Be ready to operate the unit when you pull the starter
rope. User and unit must be in a stable position when
the unit is started. Follow the Start/Stop instructions.
Use this unit for its designated purpose only.
Do not stretch too far over the unit. Always have a secure
footing and keep your balance.
When operating the unit, always hold the unit firmly with
both hands. Always hold both sides of the handle bar
firmly.
When operating the unit, always wear the shoulder belt.
Keep your hands, face and feet away from all moving
parts. Do not touch the cutting attachment while
it is rotating and do not attempt to stop it.
Do not touch the engine or muffler. These parts become
very hot while the unit is being used. They remain hot
for a short time even when the unit is switched off.
Do not let the engine run quicker than required for cutting
or trimming of lawn edges. Do not run the engine at high
speed when it is not cutting.
Always switch off the engine if you cannot start cutting
immediately or if you are moving from one place
to another.
If you strike or ensnare a foreign object, immediately
switch off the engine and check whether the unit
has been damaged. Never use the unit with loose
or damaged parts.
Stop and switch off the engine for maintenance, repairs
or when changing the cutting attachment or other
attachments. Also pull out the spark-plug terminal.
Use only original spare parts for repairs.
These parts can be purchased from your authorised
dealer.
Never use parts, accessories or attachments which
are not authorised for this unit. Otherwise, the user may
be seriously injured and the unit damaged.
In addition, your warranty may be deemed null and void.
Keep the unit clean and ensure that there are no plants
or other objects caught between the cutting attachment
and guard.
To reduce the risk of fire, please replace damaged
mufflers and spark extinguishers and remove grass,
leaves, excess lubricants and layers of soot from
the engine and muffler.
Have all repairs carried out by a repair shop only.
Operating times
Observe the national/municipal regulations concerning times
of use (if required, ask your local authority).
Working with the cutting blade
(depending on model)
Before operating the unit, please read all safety
instructions carefully.
Always keep the handle bar between the user and
cutting attachment.
NEVER cut material if the cutting blade is 75 cm
or higher above ground level.
The unit may recoil if the rotating blade strikes an object
which cannot be cut immediately. Recoils may be strong
enough to throw the unit and/or user in any direction and
may cause the user to lose control of the unit. Recoils
may occur without warning if the blade gets caught, jams
or locks. This can easily happen in areas in which the
material to be cut is difficult to see.
Never use the undergrowth blade to cut undergrowth
thicker than 12.7 mm. Otherwise, violent recoils may
occur.
Do not attempt to touch or stop the blade while it is
rotating.
A rotating blade may cause injuries, even when the
engine has been switched off or the throttle has been
released. Hold the unit firmly until the blade has come to
a standstill.
Do not run the engine at high speed when it is not
cutting.
If you strike or ensnare a foreign object, immediately
switch off the engine and check whether the unit has
been damaged. Have the repair damaged before
continuing to use the unit.
Do not use the unit with a bent, cracked or blunt blade.
Throw away bent, twisted, cracked or broken blades.
Do not sharpen the cutting blade.
The sharpened tip of the blade may break off during
operation. This may result in serious injuries.
Replace the blade.
Summary of Contents for GT-S 2-27
Page 1: ...GT S 2 27 GT S 2 27 ...
Page 2: ...2 13 23 35 59 71 47 3 3 ...
