8 21 06 8 :
MPE G -3 2 70 & 4 29 0 U s e r G ui d e
© 2 01 3 Woh le r Te ch no lo g ie s, Inc . A ll ri g ht s re s e r v ed .
18
C h a p t e r 2
Q u i c k St a r t
Se t t i n g up I n p u t s
7.
After a few seconds, the video should appear with the
MPEG
Screen
superimposed over it. If you prefer, you may remove the
superimposed
MPEG Screen
by pressing the
Menu
button twice.
Monitoring an Ethernet Stream
1.
Connect the Ethernet plug to the
ETHERNET
jack on the back
panel of the MPEG-3270 or MPEG-4290. The one jack will serve all
four screens.
2.
Press the
Menu
button to get to the
Main Menu
. Rotate the
Volume
knob to highlight the
Network Menu
selection. Press
the
Volume
knob once to enter the
Network Menu
.
3.
Rotate the
Volume
knob to each IP setting you need to change.
Press and turn the knob to make the changes. Press the
Volume
knob to exit this menu into the
Main Menu
and then press it again
to exit the
Main Menu
.
4.
Follow step
5 on page 17
through step
7
in the
Monitoring an ASI
Stream
section.
5.
Press the
Menu
button twice to exit both the
MPEG Screen
and
the
Main Menu
. Press the
Ethernet
button.
ETHUC:
will appear
in the upper left corner of the screen. After a few seconds, the
video should appear. If you prefer, you may superimpose the
N ot e :
This input does not support encrypted sources.
Video Menu
Main Menu
Audio Menu
Marker Menu
Functions Menu
OSD Menu
System Menu
Preset Menu
System Status
GPI-In Menu
Network Menu
MPEG Status
UMD Options Menu
IP Mask
Network Menu
1234
Save
Port Number
0
1
2
3
4
5
6
7
8
9
Clear
Done
IP Address
192
1
168
25
Save
255
255
255
0
Save
Gateway Address
192
1
168
16
Save
