Page
46
Decode
touch switch to
On
to enable Dolby Atmos content decoding. Set the
touch switch to
Off
to disable Dolby Atmos content decoding. Dolby Digital
Plus with Dolby Atmos content is then decoded as Dolby Digital Plus. When
Atmos Decode
is set to
Off
, then on the Dolby MetaData screen the
Atmos
3D
or
Show Video
buttons do not display.
5.
Dolby Surround Upmix
: The Dolby Surround Upmix option upmixes
channel-based content, but does not apply to audio objects. This setting
applies to Dolby Digital Plus bitstreams only. To enable Dolby Surround
Upmix, the
Dolby Atmos Decode
option must be turned
On
. Set the
Dolby
Surround Upmix
touch switch to
On
to enable to enable the Dolby
Surround Upmix option. Set the touch switch to
Off
to disable to disable the
Dolby Surround Upmix option.
Dolby Settings Screen: DD+ Tab
Figure 2-37 shows the option settings on the
DD+
tab.
Figure 2-37: Dolby Settings: DD+ Tab, Line Mode
Dolby Settings
Cancel
DRC Compression Cut
Save
Decoder
DD+
ED2
Loudness
DRC Compression Boost
<
>
0.2
<
>
0.5
Compression Mode
None
Line
RF
1.
Compression Mode
: Setting a compression mode is not required. If you do
not need or want to set the mode, leave the default selection as
Line
.
Otherwise, select the
Line
or
RF
mode as appropriate to your decoding
requirements.
2.
DRC Compression Cut
: This option is used only when the
Compression
Mode
is set to
Line
. 1.0 is equivalent to 100% Dynamic Range Control
Compression Cut Rate and each 0.1 is equivalent to 10%. Set the DRC
Compression Cut Rate in the range of 0 to 1, in increments of 0.1. Select an
option from the list by touching the
Left
(
<
) and
Right
(
>
) buttons. The
default setting is 0.
3.
DRC Compression Boost
: This option is used only when the
Compression
Mode
is set to
Line
. 1.0 is equivalent to 100% Dynamic Range Control
Compression Boost Rate and each 0.1 is equivalent to 10%. Set the DRC
Compression Boost Rate in the range of 0 to 1, in increments of 0.1. Select
an option from the list by touching the
Left
(
<
) and
Right
(
>
) buttons. The
default setting is 0.
If the
Compression Mode
is set to either
None
or
RF
, then the
DRC
Summary of Contents for iAM-12G-SDI
