© 2010 Wohler Technologies, Inc. All rights reserved.
13
AMP V Series User Guide
Rear Panel Connectors
signal present the LED will be unlit. This LED functions whether or
not the SDI digital signal is selected for monitoring through the unit.
Rear Panel Connectors
Common Connectors Descriptions
•
Power
: Attach a standard IEC-320 power cord between this
connector and mains power (100 - 250VAC, 50/60 Hz). The front
panel Power LED will glow green to indicate operating voltages are
present.
•
Selected Output
(Two, 3-Pin XLR Male): These connectors are
analog outputs of the monitor mix as selected by the left and right
Speaker Assign
channel buttons and source switches on the front
panel. The left connector outputs the left channel (Chan. A (L)) and
the right connector outputs the right channel (Chan. A (L)). Both
connectors are configured for low impedance connections and the
output signals are not affected by the volume/balance controls or
headphone mute. For XLR connector pin-out information in
Figure
1–5
below.
Figure 1–5
Selected Output 3-Pin Male XLRs
Line Level Calibration
(Six-Position DIP Switch): This DIP switch sets
the line level calibration, reference level, and PPM/VU display mode
for the level meter LED bar graph displays on the front panel. The pin-
out is silk-screened onto the the rear panel.
