WNT 80 809 070, Assembly And Operating Manual

Page: 59 / 84

Technical data
17
Technical data
Type
designation
Catalog code Holding force*
(M10 / M12)
Pull-in force
without turbo
Pull-in force
with turbo
PNG.138 80 809 100 35 kN / 50 kN 7.5 kN 25 kN
PNG.V.138 80 809 120 35 kN / 50 kN 7.5 kN 25 kN
PNG.T.138 80 809 110 35 kN / 50 kN 6.0 kN 20 kN
* Holding force when fastening the clamping pin with cylindrical
screw – DIN EN ISO 4762/12.9
Actuation pressure 6 bar
Repeatability [mm] < 0.005 mm
Installation position Any
Operating temperature + 15°C – + 60°C
Required level of cleanliness IP 30 in accordance with DIN EN 60529
Noise emission [dB(A)] ≤ 70
Pressure medium Compressed air, compressed air quality according
to ISO 8573-1:7 4 4
IP rating IP 67
The actuating pressure for the turbo function must not exceed 6 bar.
A separate maintenance unit with oiler must be used for the air
supply.
Special technical data for PNG.138
If the following technical data is adhered to, the type PNG.138 can
serve as a work surface for a welding robot:
Type PNG.138
Catalog code 80 809 100
Welding voltage 33.6 V to 46 V
Welding current 300 A to 600 A
Gas flow 4.0 l/min
Tested protective gas type Corgon 18 (82% Argon, 18% CO
2
)
Before start-up, it may be necessary to determine whether the
machine/mechanical equipment in which the quick-change pallet
system is to be installed corresponds to the provisions set out by
the Machine Directive.
If the quick-change pallet system is to be inserted outside of
these clamping and current limits, get in touch with your WNT
contact.
3
3.1