12
13
en
* Compared to WMF LINEO table blender.
Confirmed by technikzuhause.de. Resource savings refer to material usage and
transportation volume.
Energy savings refer to the maximum power consumption at maximum filling
capacity.
Start-up
▪ Clean the glass jug (3), lid (2) and closing cap (1) before starting up the appli-
ance for the first time. Ensure that you do not injure yourself on the sharp
blade.
▪ Place the appliance on an even surface and position the glass jug (3) on the
drive unit (8).
▪ Add the ingredients to the jug (3) and close it with the lid (2) and the closing
cap (1).
Additional ingredients may be added by removing the closing cap (1), even
while the motor is running.
Note: Ensure that you do not exceed the maximum filling quantity of 0.8 l. If
you are using hot, very liquid or slightly foaming food (e.g. milk), we advise
using 0.5 l as the maximum filling quantity.
Note: Never operate the appliance empty.
▪ Start the appliance by turning the selector switch (8) to the right. Start at a
low speed and increase it if necessary.
To use the
Pulse function, hold the selector switch (8) to the left on the Pulse
level. The motor will operate at maximum speed for as long as you keep the
selector switch (8) on the
Pulse level.
▪ As soon as the desired result has been achieved, switch the selector switch (8)
to the Off position . Only then should you remove the jug (3).
Attention! Risk of injury! Always wait for the blade (2) to come to a
standstill before removing the lid. Do not reach into the appliance before
the mains plug has been unplugged. Completely empty the glass jug (3)
following use. Do not leave any liquid in the jug (3).
Examples
Speed
Maximum
time
Maximum filling
quantity
Instant drinks, cocktails
Low
(min.)
40 – 60 s
500 ml
Soft fruits (e.g. bananas,
apricots)
Low
(min.)
40 – 60 s
250 g
Milkshakes / smoothies with
soft fruits
Low
(min.)
1 – 2 mins.
250 g of fruit + 150
ml of milk / juice
Soups, sauces
Medium
1.5 – 2 mins. 500 ml
Milkshakes / smoothies with
harder fruits
Medium
1.5 – 2 mins. 250 g of fruit + 150
ml of
milk / juice
Vegetables
Medium
1.5 – 2 mins. 250 g
Frappés
Medium
1.5 – 2 mins. 250 ml of
4 ice cubes
Milkshakes / smoothies
with frozen fruits, green
smoothies
High
(max.)
40 – 60 s
250 g of fruit + 150
ml of
milk / juice
Crushing ice cubes
Add a maximum of 6 ice cubes and close the glass jug (3) with the lid (2) and
closing cap (1). Move the selector switch (8) to the
Pulse level for a few seconds
and then back to the Off position . As soon as the ice cubes have fallen back to
the bottom of the glass jug (8), you can switch to the
Pulse level again for a few
seconds. Repeat the process until the crushed ice has the desired consistency.
Note: For a more homogeneous result, add some water to the ice cubes.
Glass jug
Lid with closing cap
The closing cap (1) in the lid (2) can be removed and used as a measure (10 / 20 /
30 ml) by turning it anti-clockwise.
The lid (2) reliably and tightly seals the glass jug. The lid (2) has a tab which you
can use to make it easier to remove the lid.
You can add more ingredients through the opening, even during operation.
Disassembling the glass jug
The glass jug (3) can be disassembled, especially for cleaning.
Remove the lid (2) and the closing cap (1). Place the glass jug (3) on the table
with the opening face-down and turn the locking screw (6) on the blade unit (5)
clockwise (see the figure). You can now remove the blade unit (5) and the sealing
ring (4).
To assemble the glass jug, the sealing ring (4) is first of all attached to the blade
unit (5). When doing so, ensure that the sealing ring (4) is correctly positioned on
the blade unit (5). Then insert the blade unit (5) into the glass jug. (3) and firmly
