WLD-TEC Fuego, Instruction Manual, Page: 22 / 60

22
Read these instructions carefully to familiarize yourself with the product. Please retain
these operating instruction for future reference.
Use
Safety laboratory gas burners for heating and flame sterilizing.
Ideal for use in cleanroom workbenches and laboratory.
All users who have been assigned to use this device must have read
and understood these operating instructions or have been instructed
by an expert user so that this device can be used safely without
causing danger.
ATTENTION: OPERATE THIS LABORATORy GAS BURNER UNDER
CONSTANT SUPERVISION ONLy!
!
Safety Precautions
• On unpacking the unit, check for possible transportation damages.
Do not operate the unit if damages are visible.
• After use or for any longer period of time without attendance, turn
the main gas supply off and turn off the gas burner at the function
knob (1).
• All gas connections must be adequately tightened (left-hand thread).
Ensure gas proofness with suitable test equipment. DO NOT seal up
the thread of the gas connection (10) of the laboratory gas burner with
Teflon tape, etc.
• BEFORE using the device carefully check the gas feed tube for leaks.
Check this even if the device has been installed by your distributor.
To do this, carry out all the procedures mentioned in these operating
instructions (see paragraph 1.).
• In the event that gas can be smelled: immediately turn off the gas
supply to the device. Extinguish any open flames. Pull out the mains
plug. Check all gas connections for gas proofness. If the smell of gas
persists, the appropriate authorities must be notified (janitor, gas utility
company, Fire Brigade).
LEAKING GAS CAN CAUSE A FIRE OR AN EXPLOSION. THIS MAy
RESULT IN SEVERE INJURIES, FATAL ACCIDENTS AND DAMAGE
TO PROPERTy.
• The device can be dangerous if operated or used in an incorrect
manner by untrained staff.
• An incorrect gas connection may create a hazard. Observe the
installation instructions in the manual.