3
5 ½” & 7” Housing SmartScreen Motorized Measuring
These measuring instructions cover both the 5 ½” and the 7” housing SmartScreen Motorized
Minimum width of the SmartScreen Motorized is 3’ wide (necessary to accommodate the motor within the roll tube)
Maximum width is 30’ wide
(25’ max width with Vinyl)
Maximum height is 23’ tall
(16’ max height with Vinyl)
1.
Please read before going to site to measure
2.
Bookmark the measuring and installation instructions, or print a copy to take with you on the install –
www.wizardscreens.com/technical
3.
Call to schedule a training session on installations before going to site
4.
When installing, if you have questions, call us before leaving the site
5.
Determine the installation type
a.
IUH (Inside Under Header)
i.
Housing is mounted inside the opening, under the header
i.
The housing can be attached through the top in to the header and/or through the end
caps in to the jamb
ii.
Tracks are mounted inside the opening between the jams
i.
You will need to order 2” x 2” angle to accommodate installing the tracks on the inside
of the opening
ii.
The 2” x 2” angle runs from the bottom of the housing to where the slide bar will stop at
the lowest point, or the full length of the track
iii.
The angle is attached to the jam on either side of the opening using a flat head fastener
iv.
There should be a fastener attaching the angle to the jamb at the top of the angle below
the housing, 2 fasteners in the middle spaced evenly apart, and a fastener at the bottom
close to the lowest point (minimum)
v.
The track will then be attached to the 2” x 2” angle
b.
OAH (Outside Above Header) or Standard Face Mount
i.
Housing is mounted to a wall above the opening
i.
The housing can be attached through the back of the housing in to the header
