Translation of the original operation manual Airless
17
Phoenix_BAoDB_en_1210
•
jw
Operation 6
6.3 Change of material
1. Shut down the unit
➤
Complete all steps for shutting down the pump found in
Chapter 7.
2. Clean or replace the filter insert
➤
Clean the filter insert or replace it if it is damaged.
➤
Place the cleaned or replacement filter insert into the
high-pressure filter according to Chapter 9.3.
3. Clean the suction strainer
➤
Clean the suction strainer using the solvent recom-
mended by the manufacturer of the coating, or replace
it if necessary.
4. Operation
➤
Complete all the steps found in Chapters 6.1 + 6.2
Operation.
Coating / Finishing tips
➤
Hold the spray gun at a 90° angle to the surface being
coated. If held at a different angle, the coverage will be
uneven and spotted (Picture 6.2.1).
➤
The sprayer's arm must move evenly back and forth.
➤
An even speed must be maintained.
➤
Move the spray gun parallel to the surface being
coated.
➤
Move the spray gun with the arm and not with the
wrist. Waving the spray gun will lead to uneven coating
results (Picture 6.2.2).
➤
Begin moving the spray gun before the trigger is
pulled. This ensures even, smooth overlapping results
and avoids higher coating builds when the trigger is
first pulled.
➤
Release the trigger before ceasing arm movement.
Picture 6.2.1
Picture 6.2.2
Pauses in work
➤
Apply the spray gun safety
catch at any pause in
work. (Picture 6.2.3) Im
-
merse the tip in a contai-
ner of appropriate solvent.
➤
This will avoid residue
coatings material from
hardening and blocking
the tip opening.
Exchanging the spray tip
➤
Exchange the spray tip before it is worn.
Worn tips result in increased paint consumption and
reduced spray coating quailty.
Picture 6.2.3
