Wittke StarLight, Operator'S Manual, Page: 103 / 108

Operating the W
ITTKE
™ 93
Figure 4-10 Wash-out tank
To clean up a W
ITTKE
™ unit, do the following:
1.
Drive to an appropriate clean-out area.
2.
Set the parking brake.
3.
Press the Pack button on the control panel (see Figure 3-25).
4.
Press the Stop button (see Figure 3-24) to stop the packer at the end of its packing stroke.
5.
Open the top door (see Top Door Switches (Roof Open/Roof Close) on page 63) to have a better
visibility of the hopper area.
6.
Turn off the hydraulic pump.
The hydraulic pump switch should be blue-lighted (see Figure 3-14).
7.
Complete the lockout/tagout procedure (see Locking Out and Tagging Out the Vehicle on
page 38).
8.
Enter the hopper through the side access door.
N
OTE
:
Some trucks are equipped with a streetside clean-out door, which can be used to clean the
hopper (see Figure 4-11).
Warning!
Test the side access door lockout before cleaning the hopper. See Side Access Door Proximity
Switch on page 33.
Warning! Make sure the W
ITTKE
™ is in an area where there is enough clearance to perform cleaning and
maintenance.