Removal:
1. Loosen the quick release clamps
20
of the front plane and
put it away.
2. Take out the lamp, see chapter
7.3 Changing the lamp
.
3. The secondary reflector
3
is fastened to the lamp carrier
1
with a single screw
10
. Unscrew the secondary reflector
and take it out.
Installation:
1. Place the new reflector to its position on the lamp carrier.
Fasten it with screw
10
.
2. Reinstall the lamp, see chapter
7.3 Changing the lamp
.
3. Put back the front plane and fasten it with the quick
release clamps.
7.6 Replacing the ignition unit
Danger!
This repair work must be completed by a qualified
electrical technician!
Be sure to read chapter 7.1
Before you begin
.
Removal:
1. Loosen the 8 screws which hold the back plane.
2. Take out the inside chassis with the back plane from the
searchlight housing.
3. Take out the lamp and keep at on a save place.
4. The ignition unit is mounted on the back plane. To
disconnect the cables you have to disassemble the unit
from the back plane first. Loosen the three screws which
hold the ignition unit on its stand-offs.
5. To pull off the ignition unit from its position you have to
loosen one of the lamp cables on the lamp carrier and the
cable which connects to the thermostat.
6. Now, pull out the ignition unit to a more convenient
position and disconnect all cables from it. Make sure you
can reconnect them to the new ignition unit correctly, see
chapter 3.4
Circuit diagram
.
Installation:
1. Take the new ignition unit and connect all cables, see
chapter 3.4
Circuit diagram
.
2. Place the new ignition unit on its stand-offs and screw it
tight.
3. Reconnect the lamp cable on the lamp carrier and the
cable to the thermostat.
4. Reinstall the lamp.
5. Close the back plane.
SH400-575 Rev.230903E
Replacing defective parts
29
SH400-57
5 Rev.
230903E
