O p e r a t i n g I n s t r u c t i o n s
OKTOPUS
®
GLASS-Jack
GL-CC 1200
Technical Documentation
BA 000 257
Page 22 of 28
•
all six quick couplings are plugged into the vacuum manifold when coupling the suction
frame to the vacuum system of the OKTOPUS
®
. Two suction pads are connected directly
to the vacuum manifold (1x red vacuum circuit, 1x blue vacuum circuit).
•
the suction frame is secured to the ring gear using 12 hexagon screws M8x30.
•
all 8 suction pads are mounted to the suction frame and coupled to the OKTOPUS
®
ac-
cording to figure 5.
3.8 Assembly of the extension arms
The extension arms are mounted to the suction frame for flat glass panes as follows:
⇒
Couple the OKTOPUS
®
GLASS-Jack GL-CC 1200 to a crane and position the suction
panes so that they are facing the floor.
⇒
Perform the following steps one after another for each of the four extension arms:
- Remove the lynch pin as well as the corresponding locking bolt.
- Push one extension arm with suction pad into the basic frame.
- Lock the extension arm with the previously removed locking bolt and the lynch pin.
- Couple the suction pad that is attached to the extension arm to the vacuum system.
Fig. 13:
Assembly of the extension arms
Only connect vacuum hoses and couplings of the same color (also see fig.
5)!
Make sure that after performing adjustment works all locking bolts are
completely secured by lynch pins provided by the manufacturer!
Disassembly
of the extension arms is performed in reverse order.
Lock bolt
with lynch
pin
Suction pad
Ø
400 mm
Extension arm with suction
pad
Ø
400 mm
