WireTech 5000P-10x, User Manual

Page: 21 / 28

5.4 Ethernet Menu
There are four sub menus.
5.4.1 IP Out
(Note this menu is showed only when the IP Out switch is enabled.)
The TS/IP Ethernet connector could also be configured as the output of the transport
stream over IP. The parameters listed below must be set to appropriate values for the
network over which the transport stream over IP is broadcasted.
IP Out switch: enable or disable the IP output.
IP Out status: show IP packets per second, UDP packets/s, Column FEC
packets/s, Row FEC packets/s
Protocol : you can select the transport protocol from UDP and RTP.
TS pkts per UDP: set the number of the TS packages encapsulated in one UDP
package. The valid range goes from 1 to 7.
Time to Live: set the number of the routers over which the TS over IP can be
transmitted. The valid range goes from 1 to 255.
Type of Service: you can select from normal, Min monetary cost, Max reliabliltity,
Max throughput, Min delay
TS source: select the source of the transport stream over IP streaming output.
There are 5 type of source optional:
ASI1 Input
ASI2 Input
CI De-encrypted
TUNER
Mux TS (note the Mux TS is showed only when the Mux function block is
enabled and turned on. Refer to section 5.2.7 and section 5.3.6 for how to
set the Mux function block)
Uni/Multicast Address: Enter the IP address of the multicast stream for the
Ethernet
IP Out IP In
Status
Local setting