Note:
If the TS contains PCR, you can select Auto mode. If not, please select
Fixed rate.
TS Bit rate: set the bit rate of the TS comes from the TS/IP input. The setting
range is 0
—100Mbits/s.
Note:
The setting TS Bit rate is only valid when the TS clock recovery is
configured as Fixed Rate.
5.4.3 Local IP setting
IP address: Enter the IP address for IP input or output of the unit.
Subnet mask: The network mask for the subnet to which the unit is connected.
MAC address: factory-set MAC addresses are guaranteed to be unique.
Therefore you cannot configure the address.
Gateway IP address: The gateway for the network to which this unit is
connected.
Gateway MAC address: factory-set Gateway MAC addresses are guaranteed to
be unique. Therefore you cannot configure the address.
5.4.4 Ethernet status
Link: shows the link speed
6. FAQ
1. Why is there nothing in the LCD?
Answer:
Please check whether the power supply is connected well first. If not, insert it well
and turn on the device. If there is still nothing displayed on the LCD, then the unit may be
damaged, please contact the agent for technical support.
2. Why can the DVB-S2 signal not be locked?
Answer:
Please ensure whether the input cable in connected well first. If not, insert it well. If
it is connected well, please check whether all the necessary parameters are set properly. If
not, please set the parameters properly. If the signal still cannot be locked, please check
whether the quality of the signal is out of the threshold of the Tuner. If not, then the device
might be damaged, please contact the agent for support.
3. Why can the ASI not be locked?
Answer:
Please make sure the BNC cable is connected well and there are programs
transmitted to the unit via the BNC cable.
7. Specification
Summary of Contents for 5000P-10x
Page 2: ......
